QLT LED driver DPL304E 700ma 14vmax 11watt

QLT LED driver DPL304E 700ma 14vmax 11watt

This driver works with a constant voltage and may only be used with LEDs that have the same voltage as indicated on the driver itself in this case this is 700ma. The number of LEDs that can be connected to the driver is only dependent on the wattage LEDs that is used. Always close the LEDs in series mode. Always pay attention to the polarity of the secondary cable. Thermal protection: if the temperature usually exceeds the limit values, the driver switches off and switches on again after a few seconds.

LED connection: always use a cable of 0.5 ... 1.5 mm for a maximum length of 10 m

Input wiring: use a 2x0.75 connection cable

Converters for High Brightness LEDs
Indipendent converter - IP40 - Insulation class II
Output in steady current:700mA,+/- 10%
Self-resetting protection against overtemperatures,
open circuit and output short circuits
Input voltage: 100÷250V/AC - Type /E: 190÷265V/AC - Steady output